Contact us
 |
[email protected] |
 |
3275638434 |
 |
 |
| Paper Publishing WeChat |
Useful Links
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License
Article
Itaipu Binacional Hydro Power Plant Thrust Bearing Design Optimization for Higher Efficiency
Author(s)
Piotr Pajaczkowski, Michel Spiridon, Andreas Schubert, Geraldo Carvalho Brito Junior and João Maria Marra
Full-Text PDF
XML 373 Views
DOI:10.17265/2159-5275/2015.02.006
Affiliation(s)
ABSTRACT
Hydro generators installed in Itaipu Binacional power plant with 824/737 MVA rated output power (50/60 Hz) belong to the largest ones in the world. Among many unique features, the generators are equipped with the largest hydrodynamic thrust bearings ever built (external diameter 5,200 mm, axial load equals approximately 3,600 t). This paper is an attempt to propose a new thrust bearing design with the use of the state-of-the-art technologies and simulation techniques that demonstrate a reduction of friction power losses generated by the thrust bearing. This paper is divided into two parts. Within the first one, the original thrust bearing design which was implemented in the generators is described. Related calculation results based on a TEHD (thermo-elasto-hydrodynamic) calculation software used by Alstom will be presented. A comparison between measurement results gathered in the 1980s is given. In the second part, a potential solution of a more beneficial bearing design is described. The proposed thrust bearing design modification is an implementation of Alstom’s PolypadTM coating. This modern polymer (PEEK) coating material has already been used by Alstom in projects around the world for many years. This coating allows pushing the operating parameters limits toward higher temperatures and lower oil film thicknesses far beyond the limits known for the conventional bearing materials.
KEYWORDS
Hydrodynamic thrust bearings, simulations, measurements
Cite this paper
References